9
9
25. Inspect power and control cables periodically. Replace if damaged or bare wires are
exposed.
Bare wiring can kill! DO NOT
touch live electrical components or parts.
26.
DO NOT
bypass or defeat any safety interlock systems.
27. Keep visitors a safe distance from the work area.
28. 13) Make sure guarding does not prevent the operator from performing the necessary job
tasks in a safe manner.
29.
Guards should not obscure the operator’s view when extending beyond the depth of the
chuck.
30. Always inspect the chuck and piece part in the chuck. Be aware of any potential catch points
capable of causing serious personal injury or death.
31. To avoid injuries during start-up, make sure the piece part, tooling, and tool post have
adequate clearance. Always set correct RPM for the size part being turned. If the speed is
set too high for a large piece part, there is a chance it could be ejected from the chuck
causing serious personal injury or death.
32. Always support the piece part as necessary when it extends from the chuck using a lathe
center in the tail stock or by using either a steady rest or a follow rest.
33. When the chuck and piece part are in motion,
NEVER
reach over, under, or around the
piece part to make an adjustment or to retrieve anything.
34.
ALWAYS STOP THE LATHE
when removing metallic or plastic shavings from the piece part
or the tooling.
NEVER
use your bare hands.
TECHNICAL SUPPORT
Our technical support department can be reached at 920.684.4990, and asking for the support
desk for purchased machines. Tech Support handles questions on machine setup, schematics,
warranty issues, and individual parts needs: (other than die sets and blades).
For specific application needs or future machine purchases contact the Sales Department at:
sales@baileigh.com, Phone: 920.684.4990, or Fax: 920.684.3944.
Note: The photos and illustrations used in this manual are representative only and
may not depict the actual color, labeling or accessories and may be intended to illustrate
technique only.
Note: The specifications and dimensions presented here are subject to change
without prior notice due to improvements of our products.
Summary of Contents for PL-1340E-1.0
Page 48: ...45 45 ELECTRICAL DIAGRAM...
