19
19
OPERATION
Manual Mode
1. Set the AUTO. MANU. Toggle switch to MANUAL.
2. To have table movement, select either forward or reverse.
The speed adjustment knob must be set to a value above
10 to see movement.
3. Press down and hold the foot switch. The table will
continue rotating as long as the foot switch is depressed.
When you let your foot off the foot switch, the table will
stop turning.
Auto Mode
1. Set the AUTO. MANU. Toggle switch to AUTO.
2. Press down and release the foot switch. The table will
continue rotating at the preset speed.
3. To stop the table from rotating, again press and release the foot switch.
The power indicator will light
RED
when the toggle switch is turned to the
ON
position.
The
TEST/WELD
toggle turns the circuit on
and off that controls your welding power
unit.
The power unit connects to the terminal
block as indicated by the arrow.
CAUTION:
Always wear proper eye protection with side shields, safety
footwear, and leather gloves to protect from burrs, sharp edges and HOT Parts.
CAUTION:
Switching rotation direction before coming to a complete stop
may damage motor and/or gearbox.
Summary of Contents for WP-1100
Page 17: ...15 15 G H O I J K L M N ...
Page 23: ...21 21 PARTS IDENTIFICATION DRAWING ...
Page 27: ...25 25 NOTES ...
