Bailey Approach Autograph Series Owner'S Manual Download

Page: 78 / 193

THE ALDE HEA

TING S

STEM

> Check the 12V cable is plugged into the

boiler. Check the cable is plugged into the
Alde control panel.

The boiler will not ignite on gas, but no error

message

> The system may not need to use gas heating

if also using electric heating.

> The fluids in the boiler may already be at

operating temperature.

The boiler will not heat on 230V electric

> Check the circuit breaker and any 230V

fuses.

> Check that any 230V fused spurs are on

(they will often have an LED indicator and
230V fuse).

> Check the 230V supply (also indicated on the

Standby Screen).

> The fluids in the boiler may already be at

operating temperature.

No hot water

> Check that Hot Water Ignore is not activated

on the Alde control panel.

> Check that Continuous pumping is not

activated on the Alde control panel.

> Check for other conflicting settings on the

Alde control panel or restore factory defaults.

> Check the water pump and cold water supply

to the boiler.

No central heating

> Bleed the system of air.

> Check the fluid level in the expansion tank.

> Check that the circulation pump is

responding.

> Check that hot water boost is not activated

on the Alde control panel.

> If electric heating is not being used, set it to

“Off” on the Alde control panel.

> Use gas and electric heating for best

performance.

> Check that top and bottom vents in the

furniture are not obstructed.

> Check the condition of the heat transfer fluid.

> Most vehicles will reach a comfortable

temperature within 40 mins, in non-extreme
conditions.

Set up Antimicrobial Function

To actively kill Legionella, setup the

Antimicrobial function. At 2:00 every night, the

hot water will be heated to over 65 °C for 30

mins. This further reduces the risk of Legionella.

1. Press Tool button to access the Settings

Menu (bottom right in Main Menu).

2. Press Clock button, set the time and day.

Press Return.

3. Press down arrow, until Antimicrobial

button is displayed.

4. Press Antimicrobial button to proceed.

Settings

To learn more about the Settings Menu and
programmable features of your Alde heating
system, the complete operating instructions
can be downloaded from www.alde.co.uk

To store programmable features between sites
the optional Alde 3020-420 AA battery backup

is required.

Maintenance

The Alde control panel requires no maintenance,
other than cleaning of the screen as needed.
Use a microfibre cloth to clean the touchscreen.
NB: Consider removing the Alde control panel
over winter, if the vehicle is to be kept in storage
and is susceptible to damp.

Troubleshooting

Any error messages will be displayed on the
Standby Screen. Error messages can be cleared
by removing 12V supply to the boiler for 10 secs.

The system is completely dead, the control
panel is blank

> Check the 20 mm T3.15 Amp glass fuse in

the boiler. This is located under the lid of the
black plastic service hatch, in a green plastic
fuse holder.

> Check the 12V supply to the boiler, it should

be above 12V.