INTRODUCTION
I-E96-425A
2 - 1
SECTION 2 - INSTALLATION
INTRODUCTION
This section explains how to install the NIAC03 Analog Input
Calibration Module. Read, understand, and complete the steps
in the order they appear before using the NIAC03 module.
SPECIAL HANDLING
Observe these steps when handling electronic circuitry:
NOTE: Always use the Bailey Controls Field Static Kit (part number
1948385A1 - consisting of two wrist straps, ground cord assembly,
alligator clip, and static dissipating work surface) when working with
modules. The kit is designed to connect the technician and the static
dissipating work surface to the same ground point to prevent dam-
age to the modules by electrostatic discharge.
Use the static grounding wrist strap when installing and
removing modules. Static discharge may damage MOS devices
on modules in the cabinet. Use grounded equipment and static
safe practices when working with modules.
1.
Use Static Shielding Bag
. Keep the modules in static
shielding bag until you are ready to install them in the system.
Save the bag for future use.
2.
Ground Bags Before Opening
. Before opening a bag con-
taining an assembly with CMOS devices, touch it to the equip-
ment housing or ground to equalize charges.
3.
Avoid Touching Circuitry
. Handle assemblies by the
edges; avoid touching the circuitry.
4.
Avoid Partial Connection of CMOS Device
. Verify that all
devices connected to the modules are properly grounded before
using them.
5.
Ground Test Equipment
.
6.
Use an Antistatic Field Service Vacuum
. Remove dust
from the module if necessary.
7.
Use a Grounded Wrist Strap
. Connect the wrist strap to
the appropriate grounding plug on the power entry panel. The
grounding plug on the power entry panel is connected to the
cabinet chassis ground.
8.
Do Not Use Lead Pencils to Set Dipswitches
. To avoid
contamination of switch contacts that can result in circuit
board malfunction, do not use a lead pencil to set a dipswitch.
