5
ESSENCIA DROP-IN - installation
www.bainultra.com
Some products, specifications, and services mentioned in this manual are described in pending patent applications or are protected by patents.
ESSENCIA
®
COLLECTION - DROP-IN MODELS
INSTALLATION INSTRUCTIONS
SITE PREPARATION
PLUMBING
• See faucet manufacturer’s specifications for zoning
and plan water supply location accordingly.
• Position drain according to bath’s technical specifications.
WARNING
• Baths from Essencia
®
collection cannot be drilled
for faucet installation. Faucets must be
freestanding
,
wall-mounted
models, or
installed on podium box.
BEDDING
• Before installing, ensure that the floor underneath the bath can support 1500 lb (680 kg). The bath may sit directly
on the floor. The bathtub can also sit on a concrete bed. In that case, it is recommended to isolate the concrete between two
plastic sheets: one installed on the floor and the other under the bath.
SERVICE ACCESS AND VENTILATION
• A service access is necessary. Minimum dimensions are 22” x 18” (55 cm x 46 cm)
to properly reach all electrical components of the system.
• An air vent is necessary. Minimum dimensions are: 2” x 4” (5 cm x 10 cm)
to ensure proper functioning of the turbine.
There is a technical specification sheet for each BainUltra
®
ThermoMasseur
®
which includes information such as necessary
dimensions of site before installation.
If you do not already have the technical specifications, download from the BainUltra
®
Web site at:
bainultra.com
or call us at:
1 800 463-2187
.
FLOOR
1500 LB
(680 KG)
