4
●
Squeegee ascending and descending
●
13
Opening bolt
Suction
inlet
Locking nut
Revolving
shaft
Squeegee assembly
Spring
Shaft
Revolving shaft assembly
fig.1
fig.2
Squeegee
assembly
OPERATION INSTRUCTIONS
Assembling parts
into the suction mouth on the squeegee frame to complete the assembling of the squeegee
assembly.(fig.2)
After the cleaning work, lift up the squeegee assembly and remove the brush in case that
the squeegee and the brush deform. Pull the squeegee lever upward to ascend the squeegee
assembly, and pull it downward to descend the squeegee assembly. The specific steps to
remove the brush is seen on the page 6 as the instructions of brush assembling(fig.2)
2 Brush assembling
.
Attention
Do not operate any function button while hands are touching the brush, in case of injuries.
●
●
Make sure the scrub pad is placed with the center of the pad driver and screw the pad
driver buckle. Afterwards, you can work as follows.
Rotate it 30
to the left
Three-blade
plate
fig.3
fig.4
Rotate it 30
to the right
1.Make the operation handle vertical and put the machine downward on the floor. Then,
align the brush with the three-blade plate and rotate the brush 30
to the left. After that,
the brush assembling will be finished and place the machine well.(fig.3)
2.If the brush is needed to change, hold on and rotate it 30
to the right to remove the
brush.(fig.4)
MAINTENANCE GUIDE
Trouble shooting
1 The machine socket has not been
connected well with the battery
socket.
2.The related motor switch has not
been switched on.
3.The voltage of the machine is not
normal or stable.
4.The related indicated lights blinks
abnormal.
.
1.The seal ring of the soiled water
recovery tank lid gets loose.
2.The hose hoop gets loose.
3.The water suction motor gets
loose or tilts.
4.The water suction hose is
obstructed.
5.The vacuum hose is broken.
1.Attach the seal strip properly without
space.
2.Check the hose hoop and install it
properly.
3.Open the silencer lid to make sure
the motor is installed correctly and
properly.
4.Clear out the air inlet and outlet.
5.Repair the vacuum hose.
Guangdong
Baiyun
Cleaning
Group
Co.,Ltd.
