21
GREASING PROCEDURES TO THE DRIVING CHAIN
1. Shut off the engine
2. Add light amounts of machine oil or chain grease to the driving chain.
(Too much machine oil or chain grease may cause splattering to occur.)
Attention:
The chain should be replaced when the adjusting limit has reached it’s
maximum.
ADJUSTMENT OF CHAIN
1. When chain adjustment is needed, loosen rear axle nut .
2. Turn the chain adjusting nuts on the left and right sides to adjust the
tension of the chain and to align the marking of the chain adjuster with
the engraved lines in the similar position on both sides.
3. Tighten rear axle bolt by a torque of 35-50Nm (25-37 ft.lb.).
4. Repetitively check the tension of the chain.
When the rear wheel is changed in position and the chain adjusted,
the free operating movement of the brake pedal will be affected, which,
therefore, should be checked thereafter and also adjusted if necessary.
Chain adjusting nuts
Adjustment marks
Located on each side of
Dirt Bike
15-20mm
1/2” - 3/4”
Chain adjusting nuts
Rear axle nut
