8
Baja
™
BA300
I I . YO U R S C O O T E R
Hi-Low Switch
This switch toggles the scooter’s speed between HIGH and LOW.
Press the
Hi-Low
switch to the “H” position to set the speed adjustment to High.
Press the
Hi-Low
switch to the “L” position to set the speed adjustment to Low.
Forward-Reverse Switch
This switch controls the driving direction of your scooter.
Press the
Forward-Reverse
switch to the “F” position to drive forward.
Press the
Forward-Reverse
switch to the “R” position to drive in reverse.
Thumb throttle control
This lever allows you to control the forward speed and the reverse speed of your scooter up to the
maximum speed you preset with the High-Low switch. The thumb throttle control is located on the right
handgrip.
See Figure 1.
Place your right hand on the right handgrip and your left hand on the left handgrip.
Use your thumb to press the thumb throttle control downward in order to control the speed of
movement.
Release the throttle completely to bring the scooter to a complete stop.
Release the thumb throttle control and allow your scooter to come to a complete stop before switching
between forward and reverse. When the thumb throttle control is completely released, it automatically
returns to the “stop” position and engages your scooter’s brakes.
Handbrake Lever
This lever provides you with supplemental stopping power. When in motion, release the thumb throttle
control and gently squeeze the handbrake lever to come to a stop. Be advised that using the handbrake
lever to stop may cause the scooter to stop abruptly.
NOTE: When the handbrake lever is engaged, your scooter’s rear brake lights will activate only
when the key is in the key switch and turned to the ON position.
WARNING! The handbrake is intended for use only as a supplemental brake and/or parking brake.
Parking Brake
To engage the parking brake, squeeze the handbrake lever, then press the parking brake lever toward
the handbrake to latch it in place. Squeeze the handbrake lever to release the parking brake when ready
to resume movement.
NOTE: When the parking brake is engaged, your scooter will not operate.
Horn Buttons
These buttons activate a warning horn. Your scooter must be powered up for the horn to be operational.
Do not hesitate to use the warning horn when doing so may prevent accident or injury.
NOTE: When the horn button is pressed, the scooter’s blinker lights flash once as a hazard.
