22
BAJA
™
BA300 Series
V. C O M F O R T A D J U S T M E N T S
Manual Recline Seatback Adjustment
If your scooter is equipped with a manual recline
seatback, you can adjust the seatback angle up
to 100 using the seatback release lever.
See
figure 13.
To adjust the recline angle using the seatback
release lever:
1. Pull up on the seatback release lever.
2. Lean forward or backward to the desired
position.
3. Release the lever.
Armrest Width Adjustment
You can change each armrest’s width
independently of the other.
NOTE: Changing the armrest width may
increase the overall width of your scooter.
To change the armrest width:
1. Locate the armrest width adjustment knob
on each side of the armrest receiver bracket.
See figure 13.
2. Loosen the knob.
3. Slide the armrests in or out to the desired
width.
4. Tighten the knob.
Figure 13. Seatback/Armrest Adjustment
1
2
3
5
4
Armrest Angle Adjustment
To change the armrest angle:
1. Lift the armrest straight up so that it is
perpendicular to the floor.
2. Loosen the jam nut.
3. Turn the adjustment screw to raise or lower
the front of the armrest.
4. Tighten the jam nut to lock the adjustment
screw into place.
IDENTIFICATION KEY
1. Jam
Nut
2.
Armrest Angle Adjustment Screw
3.
Armrest Height Adjustment Setscrew
4.
Seatback Release Lever
5.
Armrest Width Adjustment Knob
Armrest Height Adjustment
To change the armrest height:
1. Loosen the setscrew on the armrest.
See
figure 13.
2. Raise or lower the armrest to the desired
height.
3. Tighten the setscrew to secure the armrest.
NOTE: If the seat position on top of the rear
shroud needs to be adjusted forward or
rearward, contact your authorized dealer.
1
IDENTIFICATION KEY
1.
Seat Sliding Lever
Figure 14. Seat Sliding Lever
