Baja sportub series, Owner'S Manual

HYDRO-QUIP PORTABLE SPA EQUIPMENT 

IF YOU APPLY POWER TO SYSTEM AND DO NOTHING ELSE:

     1.  The primary filter cycle will occur in 24 hours and run for 120 min.  
          This will repeat every 24 hours.
     2.  The spa will heat up to and maintain 100º F.
          (The freeze protection mode is available if required.)

TO SET OR CHANGE THE FILTER CYCLE START TIMES:

      Refer to 

PROGRAMMING FILTER CYCLES

 in operating manual.

IF THE FILTER CYCLES ARE NOT RUNNING AT THE BEST TIMES FOR YOUR 

SLEEPING SCHEDULE, YOU MUST PROGRAM THE SYSTEM AT A PARTICULAR 

TIME OF DAY TO ADJUST THE INTERNAL SYSTEM TIME PATTERN.

Desired Filter Cycles             Programming Time        Filtering Time

1 Cycle per 24 Hour Period             8:00 PM                        8:00 PM
2 Cycles per 24 Hour Period           8:00 PM               8:00 PM & 8:00 AM
3 Cycles per 24 hour Period            2:00 PM                10:00 PM, 6:00 AM
                                                                                            & 2:00 PM

Note:  The easiest way to change the internal system time pattern is to simply TURN 
OFF ALL POWER to the spa for (10) ten seconds and then promptly start your 
programming procedure.

QUICK PROGRAMMING NOTES

11

SPORTUB 1057-58 WIRING DIAGRAM

All Universal systems leave configured 120-Volt input power.

240-Volt electrical service required:

Line 1, Line 2, and Ground.  8AWG. Minimum 

L1

GR L2

N

IMPORTANT:

 Always refer to the 

product data label (located on 
top of Control Box) for specific 
electrical information