Baja sportub series, Owner'S Manual

 
20.  

Hyperthermia occurs when the internal temperature of the body reaches a level   

           several degrees above the normal body temperature of 98.6 °F.  The symptoms   
           of hyperthermia include an increase in the internal temperature of the body, 
           dizziness, lethargy, drowsiness and fainting.  The effects of hyperthermia include   
           (1) failure to perceive heat, (2) failure to recognize the need to exit spa, (3) 
           physical inability to exit spa, (4) fetal damage in pregnant women, (5)    
           unawareness of impending hazard, (6) unconsciousness resulting in the danger    
           of drowning.

   WARNING:  The use of alcohol, drugs, or medication can  

           greatly increase the risk of fatal hyperthermia.
 

21.  

Inform all occasional users of these precautions.

23.      

SAVE THESE INSTRUCTIONS!

22

.       

For units with an Integral GFCI (ST 1050-54-56):

Warning 

- This product is 

provided with a ground fault circuit-interrupter at the end of the cord.  The GFCI 
must be tested before each use with the product operating.  Push the test button on 
the GFCI and the product should not operate.  Push the reset button on the GFCI 
and the product should operate normally.  If the product fails to operate in this 
manner, there is a ground current flowing indicating the possibility of an electrical 
shock.  Disconnect the power until the fault has been identified and corrected.

SAFETY INSTRUCTIONS

120 VOLT OZONE GENERATOR

4

120 VOLT OZONE GENERATOR INSTALLATION (optional)

The Sportub series are equipped with an ozone feed line ready for the addition of 
optional ozone generator.

Located under the spa lip and above the equipment pack please find the coiled ozone 
feed line with built in check valve. Connect this line to the barb fitting provided on the 
ozone generator leaving the excess tubing coiled under lip. This line is connected to a 
dedicated ozone injection spa jet.

The yellow 4-prong plug located on the equipment pack supplies power to the ozonator. 
Make sure the electrical pin configuration is matching and then plug in the ozonator.  
This receptacle is 

ON 

(hot) at all times.  Ozone will be injected into spa automatically 

whenever the pump is operating on 

low speed mode

 (Filtration) or High Speed.

WE RECOMMEND THAT YOU FOLLOW ALL INSTRUCTIONS PROVIDED BY THE 
OZONE GENERATOR MANUFACTURER.