1. Measurement
• Tire pressure (normal atmospheric temperature):
If out of specification, adjust.
CAUTION:
• The manometer (1) is included with the tool kit
(Nver use high pressure).
• If there is any dust or debris in the tire pressure
manometer you will not receive a correct reading.
Always take two measurements and the second
should be the one used.
WARNING:
• Uneven and improper tire pressure is not safe and
may cause the loss of control.
• Keep the proper tire pressure
• The tire pressure of both the front and rear tires
should be the same.
Normal
Temp.
Front
Rear
Tire Pressure
Standard
20kpa(0.20kgf/cm²) 25kpa(0.25kgf/cm²)
Min
17kpa(0.17kgf/cm²) 25kpa(0.22kgf/cm²)
Max
23kpa(0.23kgf/cm²) 28kpa(0.28kgf/cm²)
2. Inspection
• If wear or damage is found on the durface of the
tire, replace.
WARNING:
Using overworn tires is extremely dangerous.
If the tire is worn to the specified postion replace
immediately.
Wear Limit of tire:
Front and rear tires: 2.0mm (a)
(XIII) Inspection of rim
Inspection of rim (1) :
CAUTION:
Keep the rim in balance when replacing the rim or
tire.
WARNING:
Never attempt to repair the rim.
53
Summary of Contents for WD250U
