BA RoofOn V30 R16 12_2012 GB mit CE BAK.doc
3
INTENDED USE
This device is an automatic welding machine for overlap/tape welding of weld tarpaulin and the production of
plastic film and coated fabrics.
Weld shape overlap:
Welding lines with a width of 20, 30 or 40 mm are produced depending on the
applicable configuration.
Weld shape tape:
Tapes with a width of 40 or 50 mm are produced depending on the applicable
configuration.
Weld shape protection against vandalism:
A tape with integrated steel cable is welded on.
Weld shape measuring tape:
A profiled tape is welded on for sealing an overlap welding line.
DESCRIPTION OF FUNCTIONS
Heating system:
The hot air temperature is steplessly adjustable and electronically controlled. According to the material
thickness, the nozzle position can be adjusted steplessly.
Welding pressure:
The welding pressure can be changed by adding or reducing weight.
Drive:
The drive is steplessly adjustable and electronically controlled. The control system is designed in a way that
the set speed remains constant, independent of the load.
WARNING
•
If the power supply cable gets damaged, it has to be replaced by the manufacturer, its customer
service or by a qualified person in order to avoid danger.
•
The device must not be used by personnel (including children) with limited physical, sensory or
mental capabilities or lack of experience and/or knowledge, except when supervised by a person
who is responsible for their safety or when advised how to use the device by that person.
•
Children must be supervised in order to ensure that they do not play with the device.
•
Because of the enormous fire danger, the operating personnel must be specially briefed and
regularly instructed.
•
Fire can occur if the device is not used carefully.
•
Do not leave the device unobserved while it is in operation.
•
Demonstrate the necessary caution when operating the device near inflammable materials. Do not
operate on the same surface for longer periods of time.
•
A fire extinguisher must always be within reach in the work area.
•
The device must not be used in explosive atmospheres.
•
Heat may reach inflammable materials that are not readily visible.
•
There is a very significant risk of fire when the machine stops because of any disturbance and the
hot air device is still running (max. temperature of the air flow 650 °C). Therefore, special attention
should be placed on the subsurface and the material to be processed.
•
The welding machine must not be used on inflammable surfaces (e. g. wooden roofs and floors
made of wood)
•
The device bears the protection mark IP20 and must therefore be protected from damp and rain.
•
When using the device on roofs and tables, it could fall down due to its automatic drive system. In
order to avoid a fall, necessary precautions must be taken.
•
The welding machine can be operated up to a maximum incline or slope of 30°.
•
Warning: danger of poisoning! While processing thermoplastics or similar material, gases occur
which can be aggressive or poisonous. Avoid inhaling fumes even if they seem to be harmless.
Make sure the workplace is well ventilated or wear respiratory protection.
