Masoneilan SVI FF Bench Quick Start Manual
=
|
15
© 2019 Baker Hughes, a GE company, LLC. All rights reserved.
To run the autotune:
1. Ensure the Transducer Block is in manual, using the SVI FF DTM, as per Figure 13.
Figure 13 Transducer Block Mode
2. Select an
Auto Tune Aggressiveness
, if necessary.
3. Enter an
Auto Tune Supply Pressure
(standard unit only).
4. Click .
5. When finished, ensure the Transducer block is returned to Auto.
Appendix A: Suggested NI Hardware
Figure 14 Suggested NI Hardware
If the Transducer block is switched to Auto, it then follows the set-
point received from the AO block (if scheduled).
If you fail to switch the Transducer block to Auto, then the valve
will not be in control.
Summary of Contents for Masoneilan SVI FF
Page 20: ...This page intentionally left blank...
Page 21: ......
