4.6 Regional settings
This section enables the setting of regional information,
depending on the location of the
Aurora H2O
.
To reset the regional
settings, from the settings
menu, select locale... and
press enter. The following
screen appears.
NOTE:
Locale settings for your order have been set at the
factory and are access code protected. If you determine
a need to access regional settings, contact the factory for
assistance.
4.6.1 Setting the country code
To edit the country code,
from the regional settings
menu select country
code and press enter. The
following screen appears.
A passcode is required to
make changes.
Use the left and right
arrow keys to select each
digit to be changed. Use
the up and down arrow
keys to change the value.
When finished, press enter.
The screen returns to the
regional settings menu.
•
Country codes
= international telephone country codes.
•
Default
= 1 for U.S.
•
Option
= 81 for Japan is available to conform to METI
requirements.
4.6.2 Setting the decimal format
The decimal format option
determines whether a
decimal [.] or a comma
[,] is used as the decimal
separator. To edit the
decimal format, from the
regional settings menu
select decimal format and
press enter. The following
screen appears.
Use the left and right
arrow keys to select a
decimal [.] or a comma [,]
as the decimal separator
and press enter. The
screen returns to the
display menu.
4.6.3 Setting the date format
To edit the date format,
from the regional settings
menu select date format
and press enter. The
following screen appears.
Use the left and right
arrow keys to select the
desired date format and
press enter. The screen
returns to the previous
display.
45
Summary of Contents for Panametrics Aurora H2O
