Bugbox M
UM-20 R4.0
Page 23 of 47
Bugbox M User Manual
Entering the workstation chamber using the Ezee Sleeves
To enter the workstation via the Ezee Sleeves;
Set the glove port selector switch (Figure 10) to the correct position for the desired hand entry
Figure 13.
Hold the desired Ezee Sleeve cuff with the opposite hand.
Supporting the Ezee Sleeve cuff, push the desired hand through the cuff of the Ezee Sleeve.
Figure 14 shows this procedure;
Figure 14: Entering the cuffs of the Ezee Sleeves
Repeat the procedure for the other hand (if both hands are to enter the workstation
chamber).
Press and hold the vacuum pedal with your foot (item 1 in Figure 11) until the internal gas
volume in the sleeves has been evacuated (the sleeves will now be tight around your arms),
then remove your foot from the vacuum pedal.
Unscrew the glove port cover knob by turning it anti-clockwise (counter-clockwise).
Rotate the glove port bar until it is horizontal.
Whilst holding the glove port cover knob, push the glove port cover and your hand into the
workstation chamber slowly.
Place the glove port cover in the glove port cover holder. Figure 15 shows the glove port cover
holder.
