Bugbox Plus
UM-17 R4.0
Page 24 of 47
Bugbox Plus User Manual
To close the interlock inner door, slide the inner door forwards.
Note: The interlock inner door should only be open when transferring materials from the interlock
chamber to the workstation chamber and vice versa. The interlock inner door should not be opened
if the interlock outer door is open.
Transferring material into the workstation chamber via the interlock
To transfer material into the workstation chamber via the interlock;
Open the interlock outer door by pulling interlock door towards you using the black strip
(Figure 15).
Pull the interlock outer door down until it is horizontal.
Place the material into the interlock chamber. Do not place material on the interlock outer
door, as this may damage the workstation.
Close the interlock outer door.
Start the interlock purge cycle by pressing the interlock purge button (item 5 in Figure 9) or
the lock foot pedal on the foot switch control panel (item 2 in Figure 12). The interlock purge
cycle takes 35 seconds.
Access the workstation chamber via the Ezee Sleeves. See section 6.2.2 for details.
When the interlock purge cycle has completed, indicated by the Lock active indicator LED
(item 6 in Figure 9) not being illuminated, press the inner door button (item 2 in Figure 14).
Slide the interlock inner door backwards to open the interlock door.
Move the material from the interlock chamber into the workstation chamber.
Close the interlock inner door by sliding the interlock inner door forward.
Removing material from the workstation chamber via the interlock
To remove material from the workstation chamber via the interlock;
Open the interlock inner door by pressing the inner door button (item 2 in Figure 14) and
sliding the interlock inner door backwards.
Move the material from the workstation chamber into the interlock chamber.
Close the interlock inner door by sliding the interlock inner door forwards.
Exit the workstation chamber via the Ezee Sleeves. See section 6.2.3 for details.
Open the interlock outer door by pulling interlock door towards you using the black strip
(Figure 15). Pull the interlock outer door down until it is horizontal.
Remove the material from the interlock chamber. Do not place material on the interlock outer
door, as this may damage the workstation.
Close the interlock outer door.
