Bugbox Plus
UM-17 R4.0
Page 27 of 47
Bugbox Plus User Manual
Whilst holding the glove port cover knob, push the glove port cover and your hand into the
workstation chamber slowly.
Place the glove port cover in the glove port cover holder.
shows the glove port cover holder;
Figure 18: Glove port cover holder
Exiting the workstation chamber using the Ezee Sleeves
To exit the workstation chamber using the Ezee Sleeves;
Remove the glove port cover from the glove port cover holder (
).
Holding the glove port cover by the glove port cover knob, slowly pull the glove port cover
into the glove port with the glove port bar horizontal.
Rotate the glove port bar inside the glove port so that it is vertical.
Tighten the glove port cover knob. Do not over tighten the glove port cover knob.
Supporting the Ezee Sleeve cuff with your opposite hand, pull your hand through the cuff of
the Ezee Sleeve.
Repeat for the opposite hand if required.
Arm gas displacement volume and pressure changes
When entering or exiting the workstation chamber via the Ezee Sleeves, the internal volume of the
workstation chamber changes due to the displacement of your arms. The change in volume changes
the internal pressure. To minimise the effect of the pressure change, enter and exit the workstation
chamber slowly.
