Bugbox Plus
UM-17 R4.0
Page 30 of 47
Bugbox Plus User Manual
Figure 20 shows the internal view of the SPES;
Figure 20: SPES internal view
6.5.1.2
Using the SPES
To use the SPES;
Undo the thumb screw on the external flap (item 1 in Figure 19).
Whilst supporting the SPES external flap, swing the thumb screw to the left.
Lower the SPES external flap.
Figure 21 shows the SPES when opened;
Figure 21: SPES with external hinged flap opened
Push materials through the SPES internal flap into the workstation chamber. This should be
done as quickly as possible to minimise gas loss from the workstation chamber.
When all materials have been added, lift the SPES external flap back to its closed position.
Whilst holding the SPES external flap, swing the thumb screw right to slot into the SPES
external flap.
Tighten the thumb screw.
Note: Do not over tighten the thumb screw. Note also that it may be easier to have your right hand in
the left hand Ezee Sleeve if loading multiple items.
