Bugbox Plus
UM-17 R4.0
Page 43 of 47
Bugbox Plus User Manual
Problem
Cause
Solution
The spot light does not
illuminate
when
switched on
The bulb has blown
The fuse has blown
Contact your local distributor to arrange
replacement
Plates are drying out
Too little humidity
inside workstation
Place a tray of water inside the workstation as a
water source.
Interlock problems
Figure 36 gives a list of common interlock problems and solutions;
Figure 36: Interlock problems and solutions
Problem
Cause
Solution
The interlock inner
door will not close
The interlock inner
door is blocked
The interlock is purging
The interlock inner
door is stuck
The inner door has
stuck to the seal
Check for obstructions to closing the interlock
inner door and remove them
Wait for the interlock purge cycle to finish
Spillages can cause the interlock inner door to
stick. Clean the interlock inner door.
Press the inner interlock door release button
and pull the inner interlock door handle to
release the door from the seal. Apply a small
amount of port Lube Talc to the inner Interlock
door seal.
The interlock outer
door will not close
The interlock outer
door is obstructed
The interlock outer
door catch has broken
Check for obstructions to closing the interlock
outer door and remove them
Contact your local distributor
