Invivo
2
Plus
UM-14 Version R3.0
Page 19
Invivo
2
Plus User Manual
19.
Interlock cycle status purge.
Illuminates to indicate that the interlock purge cycle is in
progress.
20.
Interlock cycle status anaerobic.
Illuminates to indicate that the interlock chamber is in an
anaerobic condition.
Note:
For both control panels, the ANO
2
, Com. Cycle active, gas change and gas excess indicators are
not used by the Invivo
2
Plus workstation. The functions are used by the Concept Plus workstation,
which shares the same control panel as the Invivo
2
Plus workstation. LEDs are provided to blank
holes in the control panel.
Temperature controller / ultrasonic humidity controller
3.3.3
Figure 11 shows the temperature / ultrasonic humidity controller;
Figure 11: Temperature / ultrasonic humidity controller
1.
Not user accessible (For service personnel only)
2.
Not user accessible (For service personnel only)
3.
Number scrolling button. Use to move across digits. Use with buttons 4
& 5 to increase and decrease the temperature.
4.
Decrease temperature (0.1
°
C increments) or humidity.
5.
Increase temperature (0.1
°
C increments) or humidity.
For temperature control, the white value (PV- Process Value) is the actual temperature. The green
value (SV- Set Value) is the required value (the set point). All temperatures are in
°
C.
For ultrasonic humidity control, the white value is the actual relative humidity and the green value
the required relative humidity (the set point). All humidity’s are percentage relative humidity.
1
2
3
4
5
