2M-Z24018: Bak
ers P
ride - D
ant
e S
eries G
as Charbr
oiler
9
GLO-STONES C, F, L SERIES MODELS WITH SAFETY PILOT
A. Turn all burners to OFF.
B. Remove the top grid.
C. Remove a radiant.
D. Turn the shut off valve to ON.
E. Press and hold the reset (blue) button on the safety pilot valve. Wait 15-30 seconds. Light the runner
tube. DO NOT release the reset button.
(NOTE: If the runner tube does not light, wait a few seconds,
then try again. NOTE: When lighting the runner tube for the first time after connecting the unit to the gas
source, the light time will probably increase to 1-2 minutes.)
F. Wait an additional 15-30 seconds. Release the reset button. The runner tube should remain lit. (NOTE: If
the runner tube fails to ignite, repeat step 5. If the runner tube fails to ignite after three attempts, contact
an authorized Bakers Pride service agent.)
G. Replace the radiant and top grid.
H. Push and turn the burner valves to operate the individual burners as needed.
Broiler Shut Down
Turn all burners to OFF.
Turn the runner tube valve to OFF.
Glo-Stones C, F, L Series -S Models with safety pilot
Lighting and shut down of these models is identical to that of the RMB-S models except that there are no
radiants to be removed. Simply light the runner tube by inserting the ignition device through the gap between
the front burner support and the coal support as shown in the lighting instructions for the
Glo-Stones C, F, L
Series Models without safety pilot
