2
© 2010 Bakker Hydraulic Products B.V.
Nijverheidsweg 6
6662 NG Elst (Gld) Holland
Tel : + 31 481 374757 Fax : + 31 481 375280
Site :
E-mail :
Contents
Introduction
1
Table of contents
2
1.
Warnings
3
2.
RotaQ
– 55 description
4
3.
Technical information
8
4.
Using the RotaQ
9
5.
Safety
10
6.
7.
Warranty
Maintenance and repair
10
11-13
8.
Parts
14-25
Connection RotaQ
Operate the switch on the control box supplied. When the switch has been operated, a
beep will sound. Connect the RotaQ to the work tool by positioning the RotaQ on the
connection plate and then turning it clockwise. Then you connect after which the red pin
sinks into the block. Only when that has been done may the switch be turned after
which the beeps stops. You have now coupled without pressure.
If you do not connect correctly, as mentioned above, this can lead to malfunctions
because you connect under pressure and as a result the seals can break and
subsequently cause leaks.
If leaks have occurred, a seal from the bottom valves is g enerally broken and in some
cases the pin in the valve is bent.
