- Toggle to display the Max/Min reading of the Indoor & Remote Temperature.
- Press & hold for 2 seconds to clear the memorized Max/Min readings of the
Indoor channel or the selected remote channel.
3. [MENU/SETUP] button
Press and hold 2 seconds to enter clock setting mode
4. [CH] button
- Select among channel 1, 2, 3 or to enter auto scroll mode.
- Press and hold for 2 seconds to activate or deactivate the sensor
searching mode
5. [ ] button
Press once to increase the setting in CLOCK or ALARM setting mode
6. [ ] button
Press once to decrease the setting in CLOCK or ALARM setting mode
7. [RESET] button
Press once to trigger system reset and restore the factory default setting.
8. [BRIGHT/DIM] button
Toggle to select a bright LED display or a dim LED display
GETTING STARTED
This Weather Station was designed for easy set up. The following steps are
recommended for installation of the remote sensor and the weather station.
1. Install batteries in the remote sensor(s) prior to backup batteries and AC/DC
adaptor installation in the weather station.
2. The following diagrams and steps illustrate the battery installation for remote
sensor
Open the battery compartment at the bottom
of the outdoor sensor.
Install 2 pieces of AA size batteries according to the polarity mark inside the
battery compartment.
