In time mode, press and hold down the ”SET” (B1) ”button for 3 seconds, the year display 2011 starts to flash.
Now use ”+(B2) or ”-(B3)” buttons to set the correct year.
Press” B1
”
to confirm your setting, the month display starts to flash
,
Now use “+(B2)” or “–(B3)“ buttons to
set the correct month.
Press ”
(
B1
)
” to confirm your setting, the date display starts to flash
,
Now use “+(B2)” or “–(B3)“ buttons to set
the correct date.
Press “B1” to confirm your setting, the “00” display starts to flash. Now use “+(B2)” or “–(B3)“ buttons to set
correct time zone.
Press “B1” to confirm your setting, the12/24 HR display starts to flash. Now use “+(B2) ”or “–(B3)“ buttons to
set correct time format.
Press “B1” to confirm your setting, the hour display starts to flash. Now use “+(B2)” or “–(B3)“ buttons to set
correct hour.
Press “B1” to confirm your setting, the minute display starts to flash. Now use “+(B2)” or “–(B3)“ buttons to set
correct minute.
Press “B1” to confirm your setting and to end the setting procedures.
After 10 seconds without pressing any button the receiver switches automatically from setting mode to
Normal clock mode.
Setting The Daily Alarms :
In time mode
,
press ”B6” button one time, and the “
”
icon appears, again press and hold down the “B6”
button for 3 seconds until “AL” hour icon are flashing, press ”+(B2)” or "-(B3) “to set your want time, press ”B”
button confirm your setting, ” AL “ minute display start to flash, press ”+(B2)” or “–(B3)” buttons to set you want
time. Press”B6” to confirm your setting.
If you want cancel the alarm, please press “B6 “ button one time to cancel the alarm, and the “
”
icon
disappears .
To Use Snooze Alarm:
When time reaches your set alarm time ,the receiver will give beep sound to wake up, the
“
”
icon will flash.
Press ”SNOOZE/ LIGHT(B4)” button once to stop the alarm temporarily, the
“
”
icon keeps flashing ,the
alarm will beep again in 5 minutes.
To stop the alarm , press any button once , the alarm beep will stop and the “ ” icon become static alarm will
beep again same time next day.
Alarm Duration : 2 minutes.
Snooze Duration: 5 minutes
Reception Of The Radio Signal :
When you insert the batteries, all the icons on the LCD display will briefly up for 3 seconds, and you will hear
a beep tone.
The Receiver (Clock) will now start to make a connection to the wireless remote sensor. This operation takes
about 3 minutes and is displayed by a flashing reception RF symbol “
” on the LCD display.
After Receiver has created a connection to the Wireless Remoter Sensor ( after 3 minutes ), it will then begin
the automatic reception of the DCF radio signal. This operation takes up to 7 minutes and is displayed by the
flashing radio mast symbol “
” on the LCD display.
If reception is successful, then the radio mast symbol
will appear continuously on the LCD display.
The Receive automatically must scan the DCF signal at 1:00 a.m.2:00 a.m.3:00 a.m .everyday, if it receives
DCF signal at 3:00 a.m. it will stop receiving until 1:00 a.m. next day .but if it fail reception at 3:00 a.m, it will
repeat again at 4:00 a.m.5:00 a.m. This procedure is repeated automatically up to 5 times.
If this automatic process is unsuccessful, then use a sharp object to press the “ RESET (B7) “button on the
