18
Filter in the water supply
*water supply hose depends on model
If no (or not enough) water runs into the washing machine, you must first
reduce the water pressure in the supply hose:
Turn off the tap.
Choose any programme (except
q
/
B
(Rinse + Spin)/
X
(Empty)).
Press the
!
inicio/ pausa (Start/Pause) button.
Allow the programme to run for approximately 40 seconds.
Turn the programme selector to
stop
(Off).
Unplug the mains plug from the socket.
Unscrew the water supply hose from the tap.
Clean the filter with a small brush.
Reconnect the hose.
Turn on the tap.
Check whether water comes out of the end of the hose.
If water is escaping, check that the filter is correctly fitted.
Disconnect the hose from the water tap.
Clean the filter under running water.
Connect the hose.
Remove the hose from the back of the washing machine.
Pull out the filter and rinse it under running water.
Insert the filter and connect the hose.
Turn on the water tap and check whether water comes out. If water is
still escaping, check that the filter is correctly seated.
Turn off the tap.
Cleaning the filter on the tap
Cleaning the filter on the washing machine
Cleaning the filter on the washing machine