68
Poolux Wireless Panel Cradle Installation Option
The Wireless Panel comes with a charging cradle that can be installed on a wall inside the home for a convenient
display while charging. Installing the cradle is not necessary to charge the panel; it can be charged independently from
the cradle with the charge cord.
The cradle must be mounted in a location where it receives a strong signal at all times. Check to see that the panel receives
a strong signal in the location you are considering prior to installation by holding the panel against the wall and checking the
signal there. This will ensure that if a noteworthy problem occurs at the pool, the panel will be able to alert
the homeowner.
1. Find a suitable location for mounting the cradle.
The location should be convenient for the homeowner and near an
electrical outlet.
Avoid mounting the cradle near the following:
A. heat sources
B. areas of excessive moisture (such as a bathroom)
C. television sets and other electronic equipment
D.
cordless telephones
E. personal computers
F.
microwave ovens
G. electric motors
H. other wireless devices
2. Mount the cradle with the included mounting hardware as follows:
A. For sheetrock or plaster:
1.
Hold the cradle on the wall in its desired location.
2. With a pencil, mark a dot on the wall in the center of each mounting hole.
3.
Drill two 3/16” holes (1/2” to 3/4” deep) in the wall where the dots are located.
4.
Insert the plastic anchors into the two holes.
Tap the anchors with a hammer until only the round head shows.
5.
Hold the cradle over the anchors and secure by screwing the two screws into the anchors.
B. For wood surfaces:
1.
Hold the wall bracket on the wall in its desired location.
2. With a pencil, mark a dot on the wall in the center of each mounting hole.
3.
Drill two 3/32” holes (1/2” to 3/4” deep) in the wall where the dots are located.
4.
Hold the cradle over the drilled holes and secure by screwing the two screws into the holes.
3.
Using the Wireless Panel Cradle
A. Plug the charge cord into the bottom of the cradle and into an electrical outlet.
B. Set the wireless panel in the cradle.
It will snap into place, and is held magnetically.
C. Press the
Select button on the wireless panel to wake up the wireless panel if the display is blank.
D.
When the wireless panel is not in use, placing it on the cradle will ensure that it stays fully charged, has a good
signal, and can alert the homeowner to any problems in the pool.
NOTE:
Whenever the wireless panel is on the cradle or connected to the charge cord, the display will not sleep and will remain on.
INSTALLING THE WIRELESS PANEL CRADLE
