TP700
USER GUIDE
42370 Rev A
43
42
Balboa Water Group | Your Single Source Solution
Basic Installation and
Configuration Guidelines
• Use minimum 6AWG copper conductors only.
• Torque field connections between 21 and 23 in lbs.
• Readily accessible disconnecting means to be provided at
time of installation.
• Permanently connected.
• Connect only to a circuit protected by a Class A Ground Fault
Circuit Interrupter (GFCI) or Residual Current Device (RCD)
mounted at least 5’ (1.52M) from the inside walls of the spa/hot tub
and in line of sight from the equipment compartment.
• CSA enclosure: Type 2
• Refer to Wiring Diagram inside the cover of the control enclosure.
• Refer to Installation and Safety Instructions provided by the
spa manufacturer.
Warning:
People with infectious diseases should
not use a spa or hot tub.
Warning:
To avoid injury, exercise care when entering
or exiting the spa or hot tub.
Warning:
Do not use a spa or hot tub immediately
following strenuous exercise.
Warning:
Prolonged immersion in a spa or hot tub may
be injurious to your health.
Warning:
Maintain water chemistry in accordance with the
Manufacturers instructions.
Warning:
The equipment and controls shall be located not less
than 1.5 meters horizontally from the spa or hot tub.
Warning! GFCI or RCD
Protection.
The Owner should test and reset the GFCI or RCD on a
regular basis to verify its function.
Warning! Shock Hazard!
No User Serviceable Parts.
Do not attempt service of this control system. Contact your dealer
or service organization for assistance. Follow all owner’s manual
power connection instructions. Installation must be performed by a
licensed electrician and all grounding connections must be
properly installed.
WARNING! Qualified Technician Required
for Service and Installation.
CSA Compliance/Conformité
Caution:
• Test the ground fault circuit interrupter or residual current device
before each use of the spa.
• Read the instruction manual.
• Adequate drainage must be provided if the equipment is to be
installed in a pit.
• For use only within an enclosure rated CSA Enclosure 3.
• Connect only to a circuit protected by a Class A ground fault
circuit interrupter or residual current device.
• To ensure continued protection against shock hazard, use only
identical replacement parts when servicing.
• Install a suitably rated suction guard to match the maximum flow
rate marked.
Warning:
• Water temperature in excess of 38°C may be injurious
to your health.
• Disconnect the electrical power before servicing.
Attention:
• Toujours verifier l’efficacite du disjoncteur differentiel avant
d’utiliser differentiel avant d’utiliser le bain.
• Lire la notice technique.
• Lorsque l’appareillage est installe dans une fosse, on doit assurer
un drainage adequat.
• Employer uniquement a l’interieur d’une cloture CSA Enclosure 3.
• Connecter uniquement a un circuit protege par un disjoncteur
differentiel de Class A.
• Afin d’assurer une protection permanente contre le danger de
shock electrique, lors de l’entretien employer seulement des
pieces de rechange identiques.
• Les prises d’aspiration doivent etre equipees de grilles convenant
au debit maximal indique.
Avertissement:
• Des temperatures de l’eau superieures a 38°C peuvent presenter
un danger pour la sante.
• Deconnecter du circuit d’alimentation electrique avante l’entretien.
Warning/Advertissement:
• Disconnect the electric power before servicing. Keep access
door closed.
• Deconnecter du circuit d’alimentation electrique avant l’entretien.
Garder la porte fermer.
INFORMATION
Trademark | Patent Notices
BALBOA WATER GROUP and the stylized logo are
registered trademarks or applications applied for in the
US Patent & Trademark Office. All rights reserved. All
other product or service names are the property of their
respective owners.
Products are covered under one of more of the following
US Patents: 5332944, 5361215, 5550753, 5559720,
5,883,459, 6282370, 6590188, 7030343, 7, 417, 834 B2 &
Canadian Pt 2342614 plus others. Other patents both
foreign and domestic applied for and pending.
TP700 SUPPORT
All Intellectual property, as defined below, owned by or which is
otherwise the property of Balboa Water Group or its respective
suppliers relating to the Balboa Water Group BP Spa Control Systems,
including but not limited to, accessories, parts, or software relating
to the “System”, is proprietary to Balboa Water Group and protected
under federal laws, state laws, and international treaty provisions.
Intellectual Property includes, but is not limited to, inventions
(patentable or unpatentable), patents, trade secrets, copyrights,
software, computer programs, and related documentation, and other
works of authorship. You may not infringe or otherwise violate the
rights secured by the Intellectual Property. Moreover, you agree that
you will not (and will not attempt to) modify, prepare derivative works
of, reverse engineer, decompile, disassemble, or otherwise attempt
to create source code from the software. No title to or ownership in
the Intellectual Property is transferred to you. All applicable rights of
the Intellectual Property shall remain with Balboa Water Group and
its suppliers.
INTELLECTUAL PROPERTY ADVISEMENT
42370_rev A TP700 User Guide
©2021 Balboa Water Group. Single Source Solution. All rights reserved.
3030 Airway Avenue | Costa Mesa, CA 92626 | p 714.384.0384 | www.balboawatergroup.com
Specifications subject to change without notice.
