2
General Safety
THOROUGHLY READ AND UNDERSTAND THIS
MANUAL BEFORE INSTALLING, OPERATING, OR
SERVICING THIS EQUIPMENT.
IMPORTANT
!
Read these safety warnings
and instructions in this manual
completely, before installation
and start-up of the dispenser.
It is the responsibility of the
purchaser to retain this manual for reference. Failure
to comply with the recommendations stated in this
manual could damage the dispenser and void factory
warranty.
Splashing hazard.
Wear eye protection.
WARNING
!
WARNING
!
DANGER: Not for use with
fluids that have a flash point
below 100°F (38°C, examples:
gasoline , alcohol). Sparking could result in an
explosion which could result in death.
Caution
!
Because this pressurized dispenser controls
pressurized oil delivery, the following safety
precautions should be observed:
1) Check equipment regularly and repair or
replace worn and damaged parts. Be sure
fluid connections are tight before operating this
equipment.
2) Relieve pressures built up in the system before
any filling service or repair is begun. See pressure
relief procedure, this page.
3) Never alter or modify any parts of this product;
doing so may cause damage and/or personal
injury.
WARNING
!
This unit is equipped with
a pressure relief valve. Do not
remove/modify, or tamper with the valve in any
way. Any tampering with the safety valve could
result in overpressurization which could cause an
explosion.
Technical Data
Tank Size ........................................................20 gallons
Fluid Capacity .................................................16 gallons
Air Pressure Operating Range ...................... 50-100 psi
Pressure Relief Valve Setting ............................. 125 psi
Air Inlet Port ...................................... Standard tire valve
Fluid outlet hose ................................................ 1/2” x 6’
Estimated dispense time for
first 8 gallons at 100 psi
.................................. 4 minutes
Estimated dispense time for
13 gallons, from “full level” to “refill level”
at 100 psi ........................................................ 9 minutes
Wetted parts ............................................Steel, Buna-N,
....................................
Zinc Plated Steel, Polypropylene
Dimensions .............................. 36”H x 18.25” W x 23” D
WARNING
!
Always use the following Pressure
Relief Procedure whenever filling,
shutting off, cleaning, or in any way
checking or servicing the dispenser:
1) Disconnect air source from dispenser.
2) Pull ring on pressure relief valve, hold until air
pressure gage reads 0 psi.
3) After all pressure has been relieved from dispenser,
slowly open fill cap.
WARNING
!
Tank pressure limit 100 psi.
Overpressurization can result in an
explosion.
