Instruction Manual
CRI-A
- 24
MOUNTING OF DISC SECTIONS ON SIDE FRAMES (FIGURE 11)
CRI -A 40 / 44 / 48 DISCS
Figure 11
•
•
After fixing the side frames (1) on the center frames
(2), attach the disc sections (3), proceeding as follows:
3
7
6
01 -
01 -
Raise the front or back part of the harrow and place
the disc section (3) in row and coincide the holes of
the wedges (4) with the bearings, then secure using
the bolts (5), flat washer (6), pressure washer (7) and
nut (8).
02 -
02 -
Then raise the other part of the harrow and repeat
the operation, checking the concavity of the discs of
one section to the other, which must be otherwise.
03 -
03 -
After mounting, check to see if the wedges (4) are fa-
cing the concavity of the discs.
8
3
1
5
4
2
2
1
4
Repeat this procedure to mount the disc sections on the
left side frames.
IMPORTANT
When mounting the disc sections on the side frames,
ensure that the wedges of the side frames face the con-
cavity of the discs.
ATTENTION
Summary of Contents for CRI-A
