The preparation of the
CRI
and the tractor will allow you to save time in addition to
obtain better result in the field work. The following suggestions may be useful for you.
HARROW STRUCTURE
After the first day of working with the
CRI
, tighten all bolts, nuts and check the
condition of the bolts and latches of the harrow structure. Then perform a general
retightening on all screws and nuts in the harrow structure every 24 hours of work.
DISCS SECTIONS
Pay particular attention to the disc sections of the
CRI
. During the first week of use of
the
CRI
, retighten all bolts and nuts on the disc sections daily, then retighten them
periodically.
GENERAL RECOMMENDATION
01 -
Adjust the tractor according to the content of the instruction manual, always using
front and rear weights to stabilize the equipment.
02 -
Always couple to the tractor in low gear and very carefully.
03 -
When using the
CRI
, it is important to check the hitch and transverse leveling system
to make sure that the discs will have the same penetration depth into the ground.
04 -
After the hitching and leveling, the next adjustments will be made directly in the
field of work, analyzing the terrain in its texture, humidity and the types of
operations to be done with the
CRI
.
05 -
On the tractor, choose a gear that allows to maintain a certain power reserve,
guaranteeing against unforeseen efforts.
06 -
Observe the working and transport speeds specified on page 10. We do not advise
you to exceed the speeds to maintain service efficiency and avoid possible damage
to the
CRI
.
07 -
When executing maneuvers in the headwheels, first actuate the hydraulic cylinders
gradually, lifting the disc sections.
08 -
Do not uncouple any hose without first relieving the circuit pressure by turning the
control levers a couple of times with the engine off.
Instruction Manual
Summary of Contents for CRI
