Section 1
General Information
Programming & Operation 4-3
MN718
Display Mode Continued
Display Mode Screens
Action
Description
Display
Comments
Apply Power
Logo display for 5 seconds.
Display mode showing motor
speed.
No faults present. Local keypad
mode. If in remote/serial mode,
press local for this display.
Press DISP key
Display mode custom unit output
rate (only if Level 2 Custom Units
block parameters are set).
Press DISP key
Display Frequency
First Display Mode Screen.
Press DISP key
DIsplay Current
Press DISP key
DIsplay Voltage
Press DISP key
Combined DIsplay
Press DISP key
Screen to enter Fault Log
Press DISP key
Screen to enter Diagnostic Menu
Press DISP key
Exit Display mode and return to
Motor Speed display
Summary of Contents for 18H Series
Page 1: ...SERIES 18H AC Flux Vector Control Installation Operating Manual 9 97 MN718 VECTOR DRIVE ...
Page 105: ...Section 1 General Information 5 18 Troubleshooting MN718 ...
Page 109: ...Section 1 General Information 6 4 Manual Tuning the Series 18H Control MN718 ...
Page 144: ...Appendix C Appendix C 1 MN718 ...