9
1.1 STANDARD FEATURES
Table 1-1 outlines the Standard Features for the ID5601-EO
control.
Table 1-1 Standard Features
Feature
Description
Simple to Operate
Does not require programming. Uses
trimpots and jumpers which are factory set
for most applications.
Dual AC Line Voltage (115 or
208/230 Volt AC Operation)
Controls 208-230 Volt AC, 50 and 60 Hz,
3-phase motors from 115 or 208/230 Volt
AC line. (Jumper J1 must be installed for 115
Volt AC line operation.)
Motor Horsepower Selection
Jumper
Allows the drive to be used on a wide range
of motor horsepower (1/8, 1/4, 1/2, 3/4, 1
HP) without recalibration or programming.
Diagnostic LEDs
PC board mounted LEDs for Power on (ON),
Drive Status (ST), and Overload (OL).
Run/Fault Relay Output
Contacts
Can be used to turn on and off equipment or
to signal a warning if the drive is put into a
Stop Mode or a fault has occurred.
Barrier Terminal Blocks
Facilitate wiring of AC line, motor, ground
(earth) and Run/Fault Relay Output Contacts.
ON/Off AC Line Switch
Panel mounted. Used to turn on or off power
to the drive.
Pilot Light
Panel mounted. Indicates that power is
applied to the drive and the On/Off AC Line
Switch is set to the “ON” position.
Main Speed Potentiometer
Panel mounted. Provides adjustment of
motor speed.
Jumper Selections of Drive
Output Frequency
Increases the motors speed up to two times
the rated RPM.
Summary of Contents for NEMA 1 / IP40
Page 18: ...18 Figure 2 3 Drive Layout...
