BVRDTSM Touchscreen Microphone
Installation Instructions
6
BVRDTSM Touchscreen Microphone issue 1
Figure 2.2 — BVRDTSM LH Hardware Options
Table 2.2 — BVRDTSM LH Hardware Options
2.2 A
UDIO
O
UTPUTS
The BVRDTSM is equipped with 2 Audio Outputs OP1 and OP2.
OP1 is used for Live paging broadcasts. OP2 can be configured
for either;
Figure
Marked as
Function
B
All Call / Park
Factory Fit Option
All Call: Set on microphones with All Call Bypass button
Park: Set on microphones without All Call Bypass button
C
Dual OP / BGM
Default: BGM
Dual OP: Microphone audio routed out of OP1 and OP2
BGM: AUX Audio routed out of OP2
See section 2.2 for more details
N
OTE
: * If park is selected "Protocol Faults (BVRD2M MB
F/W 2.00 and above)" must be also be disabled in the
configuration. This enables compatability with legacy
systems
Figure
Marked as
Function
A
Test / Park
Default: Park
Factory use only
B
3V3 / Park*
Default: Park
Park: Hardware Bypass Access Level = 10V
3V3: Hardwired Bypass Access Level = 3V3
N
OTE
: * Option label on underside of PCB. Hardwired
Bypass Access Level must match connected BVRD2M or
BVRD2M4 configured level. See manuals for these products
for more details.
