Baldwin 8252 Series, Installation & Programming Manual

3

b. Important, 

once the connector has passed through the center hole, tuck the 

wire harness out of the way by pressing it into the notch hole as shown in figure 9.

c. 

Slide wires through the notch until mounting plate sits flush against door.

d.

 Making sure that 

exterior assembly and cylinder 

are pressed flush 

against exterior door, with Baldwin cylinder logo horizontal, insert mounting 

bolts and tighten.

e.

 Check the vertical alignment 

for mounting plate 

and 

exterior 

assembly. (See figure 10.)

f.

 Test. Using the key, retract and 

extend the bolt a few times to test 

for smooth action.

g.

 If action feels rough, loosen the 

screws and re-align the mounting 

plate and the exterior assembly. 

h.

 Repeat as required.

a. 

Carefully insert the connector of the wire harness - through the center hole of the 

mounting plate (see figure 8). 

5.  Attach the Connector to the Interior Assembly.

Continued 

4.  Install Interior Mounting plate.

a.

 Align the connector with the connector port of the interior assembly, 

matching notch to slot.

Important Note: To prevent damage, always handle the wire harness 

at the connector (do not pull wires).

Fig. 8

Mounting 

Plate

Connector

Notch

Hole

Fig. 10

Bolt

KEEP PARALLEL

Fig. 9

Connector Port

Connector

Connector

Notch

Slot

Interior

Assembly

Top view

horizontal