27
ENGLISH
EN
Before starting the engine
1. The area within a perimeter of 15 m of the person using the product
should be considered a hazardous area into which no one should
enter. If necessary, yellow warning rope, warning signs should be
placed around the perimeter of the area. When work is to be performed
simultaneously by two or more persons, care should also be taken
to constantly look around or otherwise check for the presence and
locations of other people working so as to maintain a distance between each person
sufficient to ensure safety.
2. Check the condition of working area to avoid any accident by hitting hidden obstacles
such as stumps, stones, cans, or broken glass.
IMPORTANT
Remove any obstacle before beginning work.
3. Inspect the entire unit for loose fasteners and fuel leakage. Make sure that the cutting
attachment is properly installed and securely fastened.
Starting the engine
1. Keep bystanders especially children, and animals at least 15 m away from the operating
point. If you are approached, immediately stop the engine.
2. The product is equipped with a centrifugal clutch mechanism, so the cutting attachment
might begin to rotate as soon as the engine is started. When starting the engine, place
the product onto the ground in a flat clear area and hold it firmly in place so as to ensure
that neither the cutting part nor the throttle come into contact with any obstacle when
the engine starts.
WARNING
Never place the throttle into the high-speed position when starting the engine. Never
start the engine at the cutting attachment side.
3. After starting the engine, check to make sure that the cutting attachment stops rotating
when the throttle is moved fully back to its original position. If it continues to rotate even
after the throttle has been moved fully back, turn off the engine and take the unit to an
authorized service center for repair.
Using the product
IMPORTANT
Cut only materials recommended by the manufacturer and use only for tasks explained in
the manual.
1.
Grip the handles firmly with both hands using your whole hand. Place your feet slightly
apart (slightly further apart than the width of your shoulders) so that your weight is
distributed evenly across both legs, and always be sure to maintain a steady, even
posture while working.
Summary of Contents for BXHT 6025
Page 20: ......
