32
ENGLISH
EN
6. Operation
Starting engine
WARNING
Keep the blades clear of the surrounding as they will start moving upon
starting of the engine.
1.
When first starting up after putting fuel into the machine, push the
priming pump until fuel runs out in the clear tube. Then close the
choke. Choking may not be necessary when re-starting right after
stopping the engine (OP1).
(1) Primer pump
(2) Choke lever
(3) CLOSE
(4) OPEN
2. Pull the throttle lever and push the lock button to set the lever in the
START position (OP2).
(1) Throttle lever
(2) Lock button
3. Slide the ignition switch to the engine side to set it in the ON position
(OP3).
4.
Rest the unit on a firm place. Pull the starter knob quickly (OP4).
NOTE
Avoid pulling the rope to its end or returning it by releasing the knob.
Such actions can cause starter failures.
5. When the engine has started, gradually open the choke.
6. Allow the engine to warm up for a half minute before starting
operation.
NOTE
If the engine won’t start after several attempts, open the choke and repeat pulling the
rope or remove the spark plug and dry it.
Stopping engine
1. Release the throttle lever and run the engine at idling speed for a half minute.
2. Slide the ignition switch to the STOP position.
IMPORTANT
Except for an emergency, avoid stopping the engine while pulling the throttle lever.
NOTE
If the engine won’t stop when setting the ignition switch to the STOP
position, close the choke lever and stop the engine. In this case, please
repair the machine at an authorized service center.
Summary of Contents for BXHT 6025
Page 20: ......
