33
ENGLISH
EN
Adjusting idling speed
1. When the engine tends to stop frequently at idling mode, turn the
idle set screw clockwise.
(1) Idle set screw
2. When the cutting blades keep moving after releasing the throttle
trigger, turn the idle set screw counter-clockwise.
NOTE
Warm up the engine before adjusting.
How to use
•
This machine is designed so as to cut twigs upto 28 mm thick. Cutting too thick twigs
or metal wires can not only break the blade teeth but also give damage to the drive
mechanism.
•
When trimming leaves and thin twigs, guide the blades as drawing a half circle on the
surface, and you will get a better finish.
•
Running the engine at high speed with the blades Jammed up can shorten the life
of clutch parts. When the blades have been jammed by thick twigs, stop operation
at once and draw your unit off the objects after stopping the engine. When clipping
comparatively thick twigs, move your unit slowly back and forth like a saw, and they can
be cut to a fine finish.
NOTE
When a new unit is first operated, in the first few minutes grease may come out of the gear
case. But, since this is excess grease, there is no cause for alarm. For next use just wipe it
off with the engine stopped.
Hedge trimming techniques
Trim sides of a hedge first, and then the top.
VERTICAL CUT
With the 2-sided blade use an arcing cut from the bottom upwards,
then downwards to use both sides of the blades (OP7).
HORIZONTAL CUT
In order to get the best cutting results, slightly tilt the blade (5°-10°)
towards the cutting direction (OP8).
Cut slowly, specially with thick hedges.
Summary of Contents for BXHT 6025
Page 20: ......
