Use and maintenance manual
Chipping machine BF150
22
5
CONNECTIONS
5.1
CONNECTION TO THE TRACTOR’S THREE-POINT HITCH
For cardan models only (C)
Before attaching the machine to the three-point hitch, position the tractor's safety device in such a
way that unintentional and or accidental lifting and lowering is impossible.
The three-point hitch of the tractor and the chipping machine must coincide or be adapted.
In the area of the arm tie-rods of the tractor's rear lift, there is a danger of injury due to crushing and
shearing points.
Do not use the external control to lift the machine.
ATTENTION!
Cardan models can only be used if they are connected to the tractor's three-point
hitch.
Move the tractor closer to the chipping machine
until the lift bars coincide with the three-point hitch
of the machine and connect them using the
provided pins.
Insert and lock the safety plugs into the pin hole
and make sure they are locked.
Connect the third point to the upper hitch and
adjust its length in order to position the chipping
machine parallel to the ground.
Insert and lock the safety plugs. Lock the anti-
loosening device of the third point.
Raise the machine a few centimetres off the ground and by acting on the lateral tie-rods of the lift
bars, block its lateral movement.
