Two-button remote • Control remoto de dos botones • Télécommande à deux boutons
Multi-channel remote • Control remoto multicanal • Télécommande à plusieurs canaux
Mounting your remote
Montaje del control remoto
Montage de votre télécommande
Single-channel remote • Control remoto de un solo cana • Télécommande à un canal
Snap!
¡Conecte!
Snap!
Mark screw location. Drill hole. Screw into place. Snap bracket into mount.
Insert remote.
Ubicación de tornillo marca. Agujero de taladro. Tornillo en su lugar. Coloque el
control remoto.
Marquer la vis emplacement. Percer le trou. Visser en place. Fixez le support de
montage. Insérer la télécommande.
FCC Class B Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/television technician for help.
Modifications: Any modifications made to this device that are not approved by Springs Window
Fashions may void the authority granted to the user by the FCC to operate this equipment.
For advanced technical information, contact customer service at 1-877-792-0002.
Industry Canada Notice
This device complies with Industry Canada License-exempt RSS standard(s). Operation is
subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause
undesired operation.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna
of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To
reduce potential radio interference to other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary
for successful communication.
For advanced technical information, contact customer service at 1-877-792-0002.
79074-00 (03/18) 18-8285
Springs Window Fashions, LLC • Middleton, WI 53562-1096
www.springswindowfashions.com
