CARE & MAINTENANCE
CLEANING YOUR APPLIANCE AFTER EACH USE
WARNING!
As with all cooking appliances, the metal parts and even some
plastic parts can become extremely hot to the touch. Always let the appliance
cool completely – usually 20 to 30 minutes – before cleaning.
1. ALWAYS turn the dial to the “off” position (counterclockwise) and unplug your
Electric Water Bath Multi-Cooker from the power source once you have
completed processing your foods. Allow the appliance to cool before cleaning.
2. Remove any water left in the pot using the spigot.
3. The lid, canning rack and steaming & diffuser rack can be washed in the dishwasher
or with warm soapy water, rinsed and dried.
4. It is recommended that you do not expose a hot lid to cold water. Sudden
temperature changes may cause damage to the lid.
5. Cleaning the pot: add water and soap to pot. Do not submerge. Clean interior pot
sidewalls and bottom with a soft washcloth. Let water drain into sink from spigot.
Add clean water/no soap to the pot. Rinse and release into sink from spigot. Repeat as
needed. Wipe external areas with a damp cloth and let air-dry.
6. The detachable base may be cleaned with a soft damp cloth. The power cord must be
removed prior to cleaning the detachable base. If any water should happen to enter
the power inlet, it must be dried before the appliance can be used again. Do not use
abrasive cleaners. Never submerge the detachable base in water, in other liquids or
place in the dishwasher.
7. Remove spigot assembly and clean- see cleaning instructions below.
8. Ensure all appliance parts are thoroughly dry before storing in original box.
CLEANING THE SPIGOT
REMOVING THE SPIGOT
1. Within the pot, turn the wing nut
counterclockwise until threads
have released.
2. Slowly remove the spigot body from
the pot.
3. Turn plastic ring below the spigot
handle counterclockwise to remove
handle mechanism from the
spigot body.
CLEANING
1. Wash all components in hot soapy
water or in the dishwasher.
REASSEMBLING THE SPIGOT
1. Allow parts to air dry completely
before reassembling so water does not
collect in internal components
2. Reassemble following the diagram.
(Hand tighten the wing nut and plastic
ring. Do not use a tool to tighten.)
Handle
Handle
Body
Body
Wing Nut
Wing Nut
Plastic Ring
Plastic Ring
Port
Port
Plug
Plug
12
