Page 3 of 4
STEP 1:
NOTE: Before starting assembly of this Lamp, be sure it has been unplugged.
Turning the switch off is not sufficient enough.
Pull the wires through the Base (A) from the
Bottom Column (B), then screw the Base onto
the Bottom Column, turning the Base in a
clockwise direction until tight.
STEP 2:
Pull the wires through the Bottom Column (B)
from the Top Column (C), then screw the
Top Column onto the Bottom Column, turning
the Top Column in a clockwise direction until
tight.
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
(A)
(B)
(B)
(C)
