EN
L-L 234.00-BM
24 / 40
Warning
Three-phase motors are designed by the manufacturer for
three phase operation at 400V.
For three-phase operation at 230V:
•
open the terminal box on the motor
•
remove the nuts and washers on the rods D2
•
orient the D2 rods as shown in the following figures
without moving and/or changing the position of the
cables
•
refit and tighten nuts and washers
•
close the terminal box
•
•
• Apply one of the two stickers with lot number on the nameplate of
the machine characteristic data:
• Apply the second sticker with the lot number on the Assembly and
Installation Declaration contained in the user manual:
5. MOUNTING THE DIESEL BURNER
5.1. RIELLO BURNER
• Open the box containing the diesel burner, remove it and keep the
two stickers with lot number for later use;
• Consult the user manual of the burner; and fit the burner fixing
screw onto the burner plate according to the instructions
• Secure the burner plate to the machine by using the 4xM8 screws
and the D8 x D24 washers;
• Insert the burner and fix it to the plate by tightening the nut
supplied onto the screw G;
• Locate the black cable with 7-pin Wieland plug running out of the
electrical panel and insert the plug into the socket H on the
burner;
• Remove the burner cover and secure the two hoses to the fittings
of the fuel pump already in place;
• Remove the diesel filter and its bracket and secure the bracket to
machine wall using M5 screws;
G
H
D1
D2
