61
deutsch
61
E
BIS C-6001
Opening the Processor
Opening the
Processor
BIS C-6001
Opening the processor
The BIS C-6001 processor must be opened to perform the following steps:
–
Set/change compatibility mode
–
Replace EEPROM
–
Make electrical connections (supply voltage, in-/output, I
NTER
B
US
connections).
Be sure that the unit is disconnected from power before
opening.
Remove the 4 screws on the BIS C-6001 and lift off the
cover.
Perform the desired action. To make the electrical connec-
tions, push the cables through the fittings. For additional
wiring details, see the following
.
Mounting of the cover (4 screws),
max. permissible tightening torque: 0.15 Nm
C60_1-023_819395_0508_en.p65
62
62
E
BIS C-6001
Installing the connection cables
The BIS C-6001 processor must be opened in order to make the connections for the supply
voltage, the digital input and the I
NTER
B
US
connections (see 61).
First be sure that the unit is disconnected from power.
Remove the 4 screws on the BIS C-6001 and lift off the cover.
Guide the two I
NTER
B
US
cables through the PG 11 fittings (see 63). For additional informa-
tion on wiring, see the following
.
Push the cable for supply voltage and for the digital input through the PG 9 fitting.
Close up the processor.
If the processor is equipped with an adapter:
–
BIS C-650:
Connect the read/write heads to terminals Head 1 and Head 2.
–
BIS C-670:
Connect the read/write head to terminal Head 1.
Make connections
on the BIS C-6001
processor
