Handheld Programmer
BIS L-87_
6
2.1
Intended use
2.2 General
safety
notes
2.3 Important
notes
about
rechargeable
batteries
2.4 Meaning of the
warning notes
The BIS L-87_ Handheld Programmer is a component of the BIS L identification system. Within
the identification system it is used for checking, correcting or initializing data carriers.
The Handheld Programmer may be used only for this purpose in an industrial environment
corresponding to Class A of the EMC Law.
This description is valid for processors in series BIS L-87_-1-008-….
Startup
Startup is to be performed only by trained specialists. Any damage resulting from unauthorized
manipulation or improper use voids the manufacturer's guarantee and warranty.
When starting up, observe the instructions in the manuals from PSION Teklogix GmbH.
The Handheld Programmer is to be operated only using the power supply approved for the
device
(see Technical Data on page 30)
.
Operation and testing
The operator is responsible for ensuring that local prevailing safety regulations are observed.
When defects and non-clearable faults in the Identification System occur, take the system out of
service and secure it against unauthorized use.
Attention!
Improper use, charging, disposal or replacement of the rechargeable battery may
result in an explosion! Replace the rechargeable batteries only with the same or a
type recommended by the manufacturer.
Note
Batteries and rechargeable batteries may not be disposed of with regular waste. As
an end user you are legally required to recycle used batteries or rechargeable batte-
ries. You can return batteries or rechargeable batteries after use at community collec-
tion points at no cost. You may also return batteries or rechargeable batteries to us
by mail with sufficient postage:
Balluff GmbH, Schurwaldstraße 9, 73765 Neuhausen a.d.F., Deutschland
Attention!
Use only Balluff approved power supplies.
Attention!
The pictogram used with the word "Caution" warns of a possible hazardous situation
affecting the health of persons or equipment damage. Disregard of these warning
notes may result in injury or damage to equipment.
Always take the described measures to prevent hazardous situations.
►
Safety
2
