Handheld Programmer
BIS U-870
12
Getting started
3
„Reader“
submenu
This tab is divided into three submenus:
„Reader“
,
„Read ID“
and
„R/W“
.
The following settings can be made under the
„Reader“
menu:
Protocol
EPC C1G2 is set by default.
RF Regulation
Select the RF regulation applicable in the given region. Select either „ETSI_302208“ or „FCC_
US“.
BitRate
DSB_ASK_M2_TX40RX160 is preset as the default BitRate.
Power
Power defines the power made available by the reader. Select a power from 10 mW to 500 mW.
Q-Value
Q-Value defines the minimum value of Q. This is the number of time windows per round during
the anti-collision phase. The number of time windows is 2
Q
. The value „3“ is preset as the default.
Session
Each of the four indicators refers to an identification session. After the data carrier (tag) has been
identified, this changes the status of the indicator of the session in which it was just identified.
„S0“ is preset as the default value.
Information window
Click icon
A
to call up the current program version.
Click icon
B
to call up details about the reader, such as the FW version.
Figure 6: „Configuration“ tab, „Reader“ submenu
