BIS V-6107 TCP/IP, USB
Processor Unit
12
The USB 1.1 Full-Speed-Port can be used to connect the BIS V-6107 processor unit to any USB
1.1 compatible USB port. The BIS V-6107 is detected by the PC as a system component as
soon as it is plugged in and displayed as an interchangeable data carrier with a memory capacity
of > 15 MB.
Use of the USB port as an application interface on a Windows PC (32-bit/64-bit) requires instal-
lation of a driver. After installation the processor unit functions are available on a virtual COM
port.
System requirements:
– USB 1.1 compatible USB port
– Operating system: Windows XP or higher
– Hard disk space: 72 kB
Note
To use the USB port the processor unit must be powered at the
Power
terminal (see
Section
5 Technical data
).
►
Use only shielded USB cable with a maximum length of 5 m.
For data transmission over longer distances use of active hubs or repeaters is recom-
mended.
Drivers for operating the USB port as an application interface are stored on the inter-
changeable data carrier of the BIS V group.
The Ethernet TCP/IP port can be used for integrating the processor unit into a local network. The
10BASE-T/100BASE-TX Ethernet connection can be used to send data with a transmission rate
of 10/100 MBit/s.
Note
►
Use only shielded Ethernet cable with a maximum length of 100 m.
For data transmission over longer distances the use of repeaters is recommended.
3.9 USB
3.10 Ethernet TCP/IP
3
Basic knowledge
Summary of Contents for BIS V-6107
Page 2: ...www balluff com ...