BTL6-A/G301-M_ _ _ _-A1-S115
Micropulse AT Transducer in round profile housing
10
english
6.4
Changing the operating mode
Starting from the factory setting
➥
➥
➥
➥
➥
Section 6.5 you can select the other operating modes, beginning with Mode 2 and
then Mode 3. (back to Operating Mode 1
➥
➥
➥
➥
➥
Section 6.5 Factory Setting)
Operating mode 1
➔
Single position measurement:
Output 1 = Position value for Magnet 1
Factory setting Fig. 2-2
Output 2 = Position value for Magnet 2
Operating mode 2
➔
Differential measurement:
Output 1 = Position value for Magnet 1
Output 2 = Differential value between Magnet 1 and Magnet 2
Operating mode 3
➔
Single position measurement:
Output 1 = Position value for Magnet 1
Fig. 2-3
until Serial-No. 0531xxxxx
Output 2 = Position value for Magnet 2
Use this programming sequence to change the operating mode.
6
Programming (cont.)
La = on
➔
Programming input La to 0 V
(output)
La = off
➔
Programming input La open
LED off
LED on
LED flashing rapidly
Flash time
Code
On : Off
1) Turn off power to the BTL6
2) Programming input Lb = "on"
3) Turn on power supply
4) Wait until LED comes (4 s < t < 8 s)
and then Lb = "off"
5) Wait until LED is constant on (4 s < t < 8 s)
and then Lb = "on"
6) Wait until LED is constant on (4 s < t < 8 s)
and then Lb = "off"
7) Turn power off and on.
➔
new operating mode is active
8) Check programming of the outputs and reprogram if necessary
➥
➥
➥
➥
➥
Section 6.3
The Micropulse transducer is now ready to use.
LED on
LED off
0.05 s : 0.05 s
6.5
Factory setting
The BTL is reset to factory defaults,
see Fig. 2-2
➥
➥
➥
➥
➥
page 3
1) Turn off power to BTL6
2) Programming input La = "on"
3) Turn on power
4) Wait until LED comes on (4 s < t < 8 s)
and then La = "off"
5) Wait until LED is constant on (4 s < t < 8 s)
and then La = "on"
6) Wait until LED is constant on (4 s < t < 8 s)
and then La = "off"
7) Turn power off and on. BTL is now ready to use.
Lb = on
➔
Programming input Lb to 0 V
(output)
Lb = off
➔
Programming input Lb open
LED on
LED flashing very slowly
0.5 s : 0.5 s
LED off
LED on
LED flashing rapidly
LED on
LED off
0.05 s : 0.05 s
LED on
LED flashing very slowly
0.5 s : 0.5 s
Flash time
Code
On : Off
