176
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
Plessey Set Length 2
This feature specifies one of the barcode lengths for
Plessey Length Control on page 174
. Length
2 is the maximum label length if in
For variable length decoding, a minimum and
maximum length may be set. on page 231
Mode, or the second fixed length if in
For fixed length decoding, two different lengths may be set. on page 231
Mode. Length includes
the barcode’s check, data, and full-ASCII shift characters. The length does not include start/stop
characters.
The length can be set from 1 to 50 characters. A setting of 0 specifies to ignore this length (only
one fixed length).
Table Plessey Length 2 Setting Examples
provides examples for setting Length 2. See
for detailed instructions on setting this feature.
Plessey Length 2
Setting
Examples
STEP
ACTION
EXAMPLES
1
Desired Setting
00 (Ignore
This Length)
07 Characters
15 Characters
50 Characters
2
Scan ENTER/EXIT PROGRAMMING MODE
3
Scan SELECT PLESSEY LENGTH 2 SETTING
4
Scan Two
Characters From
‘0’ and ‘0’
‘0’ and ‘7’
‘1’ and ‘5’
‘5’ AND ‘0’
5
Scan ENTER/EXIT PROGRAMMING MODE
Select Plessey Length 2 Setting
Make a mistake? Scan the CANCEL barcode
to abort and not save the entry string. You can
then start again at the beginning.
CANCEL
$CPLL2
~
DEFAULT
50 = Length 2 is 50 Characters
