177
www.balluff.com
BVS HS-Q Series
Standard Hand Held Barcode Reader
Enter/Exit Programming Mode
4
Configuration Using Barcodes
4
Configuration Using Barcodes
4.9
2D Symbologies
The reader supports the following 2D symbologies (barcode types). Symbology-dependent
options for each symbology are included in this chapter. See
page 87 for configuration of 1D barcodes.
4.9.1 2D Global
Features
The following features are common to all, or in some cases, most of the available 2D symbolo-
gies. Default settings are indicated at each feature/option with a green arrow. Also reference
for a listing of the most widely used set of
standard factory settings. That section also provides space to record any custom settings needed
or implemented for your system.
To set most features:
1
Scan the ENTER/EXIT PROGRAMMING barcode at the top of applicable programming
pages.
2
Scan the correct barcode to set the desired programming feature or parameter. You may need
to cover unused barcodes on the page, and possibly the facing page, to ensure that the
reader reads only the barcode you intend to scan.
3
If additional input parameters are needed, go to
Appendix 18, Use the barcodes in this
appendix to enter numbers as you would select digits/characters from a keypad.
, and scan
the appropriate characters from the keypad.
Complete the programming sequence by reading the ENTER/EXIT PROGRAMMING barcode to
exit Programming Mode.
2D Global Features
-
2D Maximum Decoding Time on page 178
-
2D Normal/Inverse Symbol Control on
page 179
-
2D Structured Append on page 179
2D Symbologies
-
-
-
China Sensible Code on page 183
-
-
-
-
-
-
-
Postal Code Selection on page 206
Additional information about many features can be found in the “Refer-
ences” chapter.
If you make a mistake before the last character, scan the CANCEL barcode
to abort and not save the entry string. You can then start again at the
beginning.
